Details

Parent Category: Technical Articles from Journal Back Copies

Category: Technical Articles 2002

• To keep shaped wires in place while you are forming the rest, use a piece of Perspex or glass totally covered with double-sided tape on one side. Put the wires on the sticky side with your initial drawing below the Perspex so that you can see exactly where they should go. This not only keeps the wires in place while you are completing the design, but also allows you to travel with it or store it away with another flat piece on top. Removing the wires is simply a matter of lifting them carefully with tweezers in the middle of the wire - or both ends at the same time.

 

Log in to read more....